ECU REFLASH Locations - Printable Version +- Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED (https://www.australian-hayabusa-club.com/MyBB) +-- Forum: Bike Discussions (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=35) +--- Forum: Hayabusa Gen.II (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=45) +--- Thread: ECU REFLASH Locations (/showthread.php?tid=13442) |
RE: ECU REFLASH Locations - Alky - 03-11-2014 Hi peeps , does anyone in tassie do this , ECU Reflash . Thanks in advance RE: ECU REFLASH Locations - Shifu - 04-11-2014 (03-11-2014, 06:43pm)Alky Wrote: Hi peeps , does anyone in tassie do this , ECU Reflash . Thanks in advance You can mail your ECU to Camel. He has a bench harness I think. RE: ECU REFLASH Locations - Camel - 04-11-2014 Yes, its straightforward. RE: ECU REFLASH Locations - Shordy - 04-11-2014 It's probably been covered hundreds of times on the forum, but what are all of the benefits of having the ECU flashed, specifically for a Gen 2, 2010 model. (Only mods are Yoshi Slip ons). Also, what does it cost to have it done, and are there any detrimental effects? RE: ECU REFLASH Locations - Camel - 09-11-2014 Detrimental effects? Hmmm, it will go faster, quicker and run smoother, but no detrimental effects. Perhaps others could chip in with their experiences? RE: ECU REFLASH Locations - Rev004 - 10-11-2014 RE: ECU REFLASH Locations - RaZ - 29-07-2015 RE: ECU REFLASH Locations - Camel - 30-07-2015 RE: ECU REFLASH Locations - sputs - 14-10-2015 Would it be possible to send off the ecu to be flashed first, then later dyno tune the bike without losing the changes from the ecu tune when you flash the new A/F map? RE: ECU REFLASH Locations - Camel - 15-10-2015 Yes, no problem, as long as whoever runs the dyno understands the ECU flashing software. All too often they want to use a powercommander, which isn't a bad thing, just a sad thing, particularly if they also resort to fitting a TRE. I've also been finding previously flashed ECUs with poorly or incompletely modded maps. Some people can't get their heads around the difference between unifying maps and maintaining offset. As a result I've found ECUs where the map mods were only applied to one cylinder and the other three were left stock! Camel RE: ECU REFLASH Locations - mungaman - 24-10-2015 RE: ECU REFLASH Locations - Camel - 24-10-2015 PM sent RE: ECU REFLASH Locations - Darkwalker - 13-12-2015 RE: ECU REFLASH Locations - Shordy - 14-12-2015 That's what I did, but I was told afterwards by a guy called Matt Dare on FB that it could be done in SA. You could look him up and ask him, or just ring around a couple of dealers... RE: ECU REFLASH Locations - Camel - 14-12-2015 Or you could buy an interface and pigtails from a vendor like Woolich and DIY. His install videos are easy to follow. But if you just to rid yourself of those pesky restrictions its cheaper just to send it out. Just be aware that some vendors password protect their maps. |