Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED › Bike Discussions › Technical Discussion v
Hay-wire Tach

Hay-wire Tach
rev 01
Guest
 
#18
12-06-2005, 01:19pm
Looking at the stepper motor diagrams you would wonder how a voltage could be applied to the needle shaft to actually melt the needle, particularly as the shaft assembly has an air gap between it & the outer 6 coils ? <i></i>
Reply


Messages In This Thread
Hay-wire Tach - by 02busa1 - 08-06-2005, 08:45pm
melted cheese again !! - by rev 01 - 08-06-2005, 11:03pm
Grilled cheese - by GDYUP - 08-06-2005, 11:20pm
Re: Hay-wire Tach - by Evil - 09-06-2005, 11:25am
Re: Hay-wire Tach - by rocket rod 7777 - 09-06-2005, 12:18pm
muppet show - by rev 01 - 09-06-2005, 12:56pm
Re: muppet show - by Djpete - 09-06-2005, 05:44pm
Tacho needle - by BEAR - 09-06-2005, 10:13pm
needle - by rev 01 - 09-06-2005, 10:18pm
No Tacho joke!!! - by 02busa1 - 10-06-2005, 08:36am
Re: No Tacho joke!!! - by rocket rod 7777 - 10-06-2005, 10:39am
Re: No Tacho joke!!! - by Maj750t - 10-06-2005, 01:49pm
Re: No Tacho joke!!! - by BUSGO - 10-06-2005, 10:10pm
Re: obviously its the stepper motor!!!! - by 02busa1 - 11-06-2005, 08:09am
? - by Evil - 11-06-2005, 10:05am
Nutty Tach!!!!! - by 02busa1 - 11-06-2005, 12:18pm
stumped - by rev 01 - 12-06-2005, 01:19pm



Users browsing this thread: 1 Guest(s)