07-04-2013, 08:11am
Axe
07-04-2013, 12:38pm
hmmm No.
but i have done the swap.
Gen 2 akropovic headers on a gen 1, the end orientation of the end can will be off, but a quick cut and weld and its sweet.
If using stock headers you will prob be able to just heat up and bend them with a pry bar.
As far as mounting to the engine, both are the same.
Axe
but i have done the swap.
Gen 2 akropovic headers on a gen 1, the end orientation of the end can will be off, but a quick cut and weld and its sweet.
If using stock headers you will prob be able to just heat up and bend them with a pry bar.
As far as mounting to the engine, both are the same.
Axe
CaptainRob
07-04-2013, 02:14pm
(07-04-2013, 12:38pm)Axe Wrote: [ -> ]hmmm No.
but i have done the swap.
Gen 2 akropovic headers on a gen 1, the end orientation of the end can will be off, but a quick cut and weld and its sweet.
If using stock headers you will prob be able to just heat up and bend them with a pry bar.
As far as mounting to the engine, both are the same.
Axe
Tnks
07-04-2013, 06:48pm
Not sure about the standard headers if thats what your talking about but i know that the Brocks sidewinder and the gen3 i think from memory that what it was fit from Gen1 - Gen2 if thats any help