18-09-2006, 07:58pm
Xhiler8r
18-09-2006, 09:08pm
Its gone mate sorry Cheers Bill
The man without a bike
The man without a bike
DAN85
18-09-2006, 09:10pm
hot digity damn Dirty Dan For Life
DAN85
18-09-2006, 09:24pm
so with the hole o2 sensor anyway to get around that? alternatively how long does it take to remove the baffles? Dirty Dan For Life
Xhiler8r
18-09-2006, 09:32pm
mate you arent actually removing them it is more of drilling a hole in them I actually sloted my hole instead of just drilling them out
media.putfile.com/M109R-Stock-Pipe-Mod
media.putfile.com/Stock-Pipe-Mod-Sounds
Cheers Bill
The man without a bike
media.putfile.com/M109R-Stock-Pipe-Mod
media.putfile.com/Stock-Pipe-Mod-Sounds
Cheers Bill
The man without a bike
DAN85
18-09-2006, 10:12pm
did u slot a hole in all of them or just the last plate? is the sound worth it or not
Dirty Dan For Life
Dirty Dan For Life
Xhiler8r
18-09-2006, 10:33pm
just the end plate and I drilled out the centre of the baffle with the holesaw and yes the sound is definately worth it I did find it had a bit of a flat spot down low but the TRE fixed that really well get around 2 k on the clock and the pipes get louder or watch the video and listen to the difference it really does sound like that I went for a ride with a stocker he started his and you could hear it nicely but then i started mine and his sounded like it was turned off the choice is your mate and it still stays road worthy also not too loud just really beefy Cheers Bill
The man without a bike
The man without a bike
Xhiler8r
18-09-2006, 10:36pm
if ya gonna do it go with a 1 1/4 " holesaw I used 1 5/16 and it was a really tight fit that eneded up losing the holesaw inside the can was a major effort in removing it but all ended up good Cheers Bill
The man without a bike
The man without a bike