+- Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED (https://www.australian-hayabusa-club.com/MyBB)
+-- Forum: Bike Discussions (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=35)
+--- Forum: Technical Discussion (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=5)
+--- Thread: Clutch Setting for Busa (/showthread.php?tid=11894)
Clutch Setting for Busa - Bill Gaheer - 23-03-2009
HI,
Just installed new Clutch, today I noticed that when the bike is not ON and I put it in gear it seems that bike is engaged in gear and wont move ahead even with lever completely depressed.
It works fine when the bike is turned on - it moves on half clutch (but noticed a shudder)
What am I missing?
Question 2>
I have ordered Starter clutch, do we have any existing post on DIY on replacing Starter clutch.
Cheers,
Bill
RE: Clutch Setting for Busa - spamanglenn - 23-03-2009
just the oil on the fibres and if it shudders maybe a couple of warped steels.Also check if you put the cushion ring back in properly.
RE: Clutch Setting for Busa - Bill Gaheer - 23-03-2009
spamanglenn Wrote:just the oil on the fibres and if it shudders maybe a couple of warped steels.Also check if you put the cushion ring back in properly.
Hi Spamanglenn,
The fiber were dipped in Oil for good 24 hours. Steel Plates looked fine - I have a working clutch which I replaced.
I coundnt understand "check if you put the cushion ring back in properly' - my be if you can explain a bit it would help.
cheers,
Bill
RE: Clutch Setting for Busa - Maj - 24-03-2009
New plates may drag a litle till run in, had a set of non oem plates do that to me once before, actually dragging me through the lights at the drags, put them on the shelf and there still there 2 yrs later..