+- Welcome to The Australian Hayabusa Club Forum - ARCHIVE ONLY VERSION - NEW REGISTRATIONS & POSTS DISABLED (https://www.australian-hayabusa-club.com/MyBB)
+-- Forum: Bike Discussions (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=35)
+--- Forum: Hayabusa Gen.II (https://www.australian-hayabusa-club.com/MyBB/forumdisplay.php?fid=45)
+--- Thread: engine mounts torque and sequence (/showthread.php?tid=19937)
engine mounts torque and sequence - pete - 13-01-2013
ive tried searching without luck,
was wondering if there is a sequence
for tightening the engine mount bolts and
the torque settings for those bolts?
tia
RE: engine mounts torque and sequence - Batfink - 14-01-2013
I posted a complete set of the Service manual for a gen 1 in Tech Discussions... look at Section 3-13
Shows no sequence for tightening engine mount thrust adjusters but gives 10N-m or 1.0 kgf-m or 7.0 lb-ft
lock nut is 45 N-m, 4.5 kgf-m or 32.5 lb-ft
hope this helps
RE: engine mounts torque and sequence - pete - 14-01-2013
yep, thanx tony.