clutch slave cylinder dirt excluder seal

[Volvi]

rev said a while back; :I've been informed that the part number for the late model clutch slave cylinder dirt excluder seal is:

23166-02F20..............about $25."

Thx rev, got it today from Mick Hone for $10 ($11.60 listed price)

hope to fit it sometime this week with Rods help. thx Rod in advance.
<i></i>

[Haemaglobin]

extremely easy to fit, take off your sprocket cover (remove side panel, water container and gear lever to get to it) and look at it, you may or may not have a rubber seal sitting in the recess of the sprocket cover...or the seal may be on the clutch pin (mine didnt have one on at all). Either way, remove the rubber seal that is there and put the new one on (just pulls off and on). Then replace everything.

Simple 10 min job.

Ive not had a problem with dirt in the fluid since. <i></i>

[GDYUP]

I still get shitty fluid even after fitting this cheese seal!:">

I think I might have the limited edition 02 self saucing model! Extremley rare (Not) and never saught after....... <i></i>

[rev 01]

That's coz you're putting the old shit back in GDY typical Clansmen, won't or can't throw anything away

Speaking of Clansmen:

...................WARNING WARNING WAR STORY!!!!!!................

Click off now or forever hold your peace if I've bored you shitless before

I used to work with this old Scotchie, during a lunch break I noticed him putting his old used tea bags back in his Gladstone Bag

A few days later he's got a big horrible stewy cuppa going with at least a dozen old dried out tea bags fighting for space in his cup

Never short of a quid though old Jimmy Haggis <i></i>

[GDYUP]

:"> <i></i>

[rev 01]

<i></i>