New member down....
#1
I learnt yesterday that the owner of the new TWOWHEELSUPERSTORE shop and newbie member of our club, Weebnuts, had a bad crash on Sunday arvo up on the Buladelah mountain.
He was riding his k7 gixxer thou with a friend and went into the armco railing.
He is currently in the TAREE hospital with many broken bones but is going to be ok.

If there are any members up around Taree, I'm sure that he would be grateful of a visitor or two. He will be in the hospital until after the weekend.
I might go for a spin up there on Saturday afternoon to see if I can cheer him up a bit.

In the meantime it is operations as normal in the shop, so I'm sure that every sale will help him get back into action.
"If time catches up with you. You're going too slow!"
Regards BUSGO
Reply


Messages In This Thread
New member down.... - by BUSGO - 29-11-2007, 08:39am
RE: New member down.... - by Volvi - 29-11-2007, 08:47am
RE: New member down.... - by F.B.R.1347 - 29-11-2007, 09:06am
RE: New member down.... - by BusaNation - 29-11-2007, 09:50am
RE: New member down.... - by NEMESIS - 29-11-2007, 10:04am
RE: New member down.... - by Mutha - 29-11-2007, 01:05pm
RE: New member down.... - by Slowdownjack - 29-11-2007, 01:18pm
RE: New member down.... - by Gnarbunkle99 - 29-11-2007, 01:30pm
RE: New member down.... - by andcad - 29-11-2007, 04:20pm
RE: New member down.... - by CapeBusa - 29-11-2007, 05:29pm
RE: New member down.... - by Astro - 29-11-2007, 06:26pm
RE: New member down.... - by wally - 29-11-2007, 09:04pm
RE: New member down.... - by ROD - 29-11-2007, 10:05pm
RE: New member down.... - by LOAFIE - 29-11-2007, 10:41pm
RE: New member down.... - by Doc - 30-11-2007, 01:05am
RE: New member down.... - by jaycbr250 - 30-11-2007, 07:03pm
RE: New member down.... - by Busa Boy - 30-11-2007, 07:40pm
RE: New member down.... - by BUSGO - 01-12-2007, 04:38pm
RE: New member down.... - by rjw3105 - 03-12-2007, 03:25pm
RE: New member down.... - by bear - 03-12-2007, 08:34pm
RE: New member down.... - by jaycbr250 - 03-12-2007, 09:17pm



Users browsing this thread: 1 Guest(s)