Custom Brakes (updates)
#31
Ok im back ONLY to post on this thread , the latest installment on this build is new master cyc , They also sell am matching clutch unit as well , i have purchased a set as im also doing a clutch upgrade with a brocks kit


http://www.ebay.com.au/itm/130726194665?...1423.l2649


Attached Files Thumbnail(s)
   
Reply
#32


Attached Files Thumbnail(s)
   
Reply
#33
Reply
#34
ok guys well my brake upgrade is all complete and going well now , latest mod is the RACETECH suspension additions that have been a warm welcome for my busa .

[Image: b7b952.jpg]
Reply
#35
Ok guys here is the final installation of the custom brake upgrade guys


i purchased a set of NISSN masters from a company in the USA these are the same units they use on the ZX14 so you can sorce a set of short levers for them as well ,

[Image: 29ztted.jpg]
[Image: nl78jn.jpg]
[Image: 3504h8l.jpg]
Reply
#36
Reply
#37
Reply
#38
So do you find this is a good upgrade ??
Reply
#39
exactly the same masters as mine ,awesome bit of kit,
Reply
#40
(01-12-2012, 08:34pm)revhead Wrote: exactly the same masters as mine ,awesome bit of kit,


Yeah pete that's cause I asked you where you got your from lmfao

Reply
#41
Anyone know if any of these adapter / conversions will work
with GSXR750K4 radial calipers?

Just been offered a set and can't find the info I want.
Pretty sure there's different spacing between various
makes and models of calipers.

Is GSXR750K4 onto a Gen1 Busa do-able with
an off the shelf kit?
Reply
#42
(14-01-2013, 08:50am)Tony Nitrous Wrote: Anyone know if any of these adapter / conversions will work
with GSXR750K4 radial calipers?

Just been offered a set and can't find the info I want.
Pretty sure there's different spacing between various
makes and models of calipers.

Is GSXR750K4 onto a Gen1 Busa do-able with
an off the shelf kit?

tony do you have the measurments for the caliper bolt holes mate i can measure them up against mine here mate
Reply
#43
No, not even seen them!

From memory I think they're gold but not sure of make or spacing.

He's not home right now, i'll try and grab him later.

$50 with good pads and the old lines for the pair ?
Reply
#44
Kev,

I went around and picked these up.
Not fantastic condition but I think they'll clean up.

He chucked in a LOT of other stuff (spanners/Sockets etc)
so couldnt complain at $50 for the lot.

TOKICO's with (i think) 108mm spaceing.

[Image: tokico108.jpg]
Reply
#45
Excellent mate will have an answer in the morning for ya mate
Reply




Users browsing this thread: 1 Guest(s)