27-05-2016, 06:49pm
75MM inlet mate, here's the filter i have on the way. Should look all right if i get the stencil right and don't balls the hole up!
The business end of the fuel tank, now leak free. Loaded the generic power commander fat map and cranked it up apparently i put the fan a little to close to the header tho.. FMU seems to be doing its job, the bov is opening and the boost gauge shows a steady needle.
Tomorrow's job, trim all the fan blades to get it back in balance. Oh and modify the lower rad mount again 😑
So far so good really!
Sent from my GT-I9507 using Tapatalk
The business end of the fuel tank, now leak free. Loaded the generic power commander fat map and cranked it up apparently i put the fan a little to close to the header tho.. FMU seems to be doing its job, the bov is opening and the boost gauge shows a steady needle.
Tomorrow's job, trim all the fan blades to get it back in balance. Oh and modify the lower rad mount again 😑
So far so good really!
Sent from my GT-I9507 using Tapatalk