Hi Everyone,
My son and I wanted to see how we could modify a stock exhaust on the 2014 Hayabusa 1300r without making it look suspicious.
First grind rivets on chrome cap. remove cap. cut through outer only - 15mm from end. then cut through whole muffler around 35mm from edge. see photos for additional bits.
Then test cut through middle to determine where to cut behind pipe which connects the middle section. Once determined, cut behind the pipe (tape to determine even cut).
knock out welds on the plate inside.
http://someimage.com/291J8eF
http://someimage.com/mEQgjsx
http://someimage.com/aGn0iS4
Once out, should look like this.
http://someimage.com/2PZtaIP
Then push end section lip prepared earlier into the gap between inner and outer shell of now empty muffler.
http://someimage.com/bNa6s0U
http://someimage.com/qGmgohT
Make sure you clean out some heat insulation to be able to fit it correctly.
http://someimage.com/PEn1Vxl
http://someimage.com/H8oEUWs
Pop rivet chrome cap back on and then place 2 pop rivets each face to fix into the join and stop the end section falling off.
http://someimage.com/ey5VG37
http://someimage.com/HRDoqYV
http://someimage.com/xj4qJaq
Finished!!! Looks stock huh?
http://someimage.com/KjQPiTq
http://someimage.com/blB7hAz
http://someimage.com/c6gnziF
http://someimage.com/1lhz7aD
My son and I wanted to see how we could modify a stock exhaust on the 2014 Hayabusa 1300r without making it look suspicious.
First grind rivets on chrome cap. remove cap. cut through outer only - 15mm from end. then cut through whole muffler around 35mm from edge. see photos for additional bits.
Then test cut through middle to determine where to cut behind pipe which connects the middle section. Once determined, cut behind the pipe (tape to determine even cut).
knock out welds on the plate inside.
http://someimage.com/291J8eF
http://someimage.com/mEQgjsx
http://someimage.com/aGn0iS4
Once out, should look like this.
http://someimage.com/2PZtaIP
Then push end section lip prepared earlier into the gap between inner and outer shell of now empty muffler.
http://someimage.com/bNa6s0U
http://someimage.com/qGmgohT
Make sure you clean out some heat insulation to be able to fit it correctly.
http://someimage.com/PEn1Vxl
http://someimage.com/H8oEUWs
Pop rivet chrome cap back on and then place 2 pop rivets each face to fix into the join and stop the end section falling off.
http://someimage.com/ey5VG37
http://someimage.com/HRDoqYV
http://someimage.com/xj4qJaq
Finished!!! Looks stock huh?
http://someimage.com/KjQPiTq
http://someimage.com/blB7hAz
http://someimage.com/c6gnziF
http://someimage.com/1lhz7aD